欧美区高清在线,久久成人免费视频,久久国产精品视频在线观看

RTP600W厚膜無感電阻10Ω100Ω200Ω300Ω500Ω1MΩ

	價格：10 元(人民幣)	產地：深圳市
	最少起訂量：1只	發貨地：本地至全國
	上架時間：2025-12-26 10:52:24	瀏覽量：240
	深圳市華鑫歐電子有限公司
	經營模式：生產加工	公司類型：私營有限責任公司
	所屬行業：電阻器、電位器	主要客戶：艾默生，中興通訊，TCL,華為技術，長城集團...
	在線咨詢

聯系方式

聯系人:吳偉 (先生)	手機:13554875208
電話:	傳真:
郵箱:szhxwuwei2008@163.com	地址:深圳市寶安區石巖鎮洲石路石頭山工業區2號廠房3樓

詳細介紹

RTP600

功率型厚膜無感電阻器 Power type Thick film Non inductive Resistor

l 底板中心溫度≤85℃ 額定功率 250W～800W

l Base plate center temperature ≤ 85℃ Rated power 250W～800W.

l 特殊設計的外型結構，芯片和外殼之間用彈簧聯接，用兩個螺絲固定安裝，能保證散熱片附著壓力在 120 到 160 牛頓之間。

l The specially designed structural shape connects the chip and the casing with springs and is securely mounted with two screws, ensuring that the pressure of the heatsink attachment is between 120 and 160 Newtons.

l 搭配合適的散熱器使用時，功率可達到 2000W

l When used with a suitable radiator, the power can reach 2000W

主要應用于變速驅動器、供電、控制設備、通訊、自動控制、發動機控制等。適合逆變器電路、脈沖電路、高頻電路。

Mainly used in variable speed drives, power supply, control equipment, communication, automatic control, engine control, etc. Suitable for inverter circuits, pulse circuits, and high-frequency circuits.

降功率曲線斜率（熱阻）：RTP600:8.57W/K（0.12K/W）

額定功率	阻值范圍	阻值允許偏差	電阻溫度系數	最大工作電壓	耐電壓
Rated	Resistance	Resistance	Temperature coefficient	Maximum working	Withstanding
power	range	Tolerance	（PPM/℃）	voltage	voltage
600W	0.5Ω-1MΩ	±1%、±5% 、±10%	±150	5000VDC	6KV/Min

RTP600

功率型厚膜無感電阻器 Power type Thick film Non inductive Resistor

試驗項目	試驗條件	性能指標
Test items	Experimental conditions	Performance indicators

溫度快速變化	-55℃～+155℃，經五次循環；極限溫度暴露時間：	電阻器應無可見損傷且標志清楚
溫度快速變化	30 分鐘；轉換時間：1～2 分鐘	The resistor should have no visible
Rapid temperature	30 分鐘；轉換時間：1～2 分鐘	The resistor should have no visible
Rapid temperature	-55 ℃ to+155 ℃, after five cycles; Extreme temperature	damage and clear markings,
changes	-55 ℃ to+155 ℃, after five cycles; Extreme temperature	damage and clear markings,
changes	exposure time: 30 minutes; Conversion time: 1-2 minutes	△R≤±（0.5%R+0.05Ω）
	exposure time: 30 minutes; Conversion time: 1-2 minutes	△R≤±（0.5%R+0.05Ω）
溫度系數		TCR 在±150X10-6/K 之內
Temperature	25℃～105℃	TCR 在±150X10-6/K 之內
Temperature	25℃～105℃	TCR within ± 150X10-6/K
coefficient		TCR within ± 150X10-6/K
coefficient
	正常氣候條件下，在電阻器的金屬散熱板與引出端之間
	測試絕緣電阻，試驗電壓（直流）為 500±5V	絕緣電阻應≥10GΩ
絕緣電阻	Under normal weather conditions, test the insulation	The insulation resistance should be
Insulation resistance	resistance between the metal heat dissipation plate of the	≥10GΩ
	resistor and the lead out terminal, with a test voltage (DC)
	of 500 ± 5V
	施加額定功率 2 倍的直流電壓（Us≤1.5Umax）	電阻器應無可見損傷且標志清楚
過載	時間為5秒	The resistor should have no visible
Overload	Apply a DC voltage of twice the rated power	damage and clear markings,
	(Us ≤ 1.5 Umax) for 5 seconds	△R≤±（0.5%R+0.05Ω）
穩態濕熱		電阻器應無可見損傷且標志清楚
穩態濕熱	溫度：40±2℃；濕度 95%；時間：56 天	The resistor should have no visible
Damp heat steady	溫度：40±2℃；濕度 95%；時間：56 天	The resistor should have no visible
Damp heat steady	Temperature: 40 ± 2 ℃; Humidity of 95%; Time: 56 days	damage and clear markings,
state	Temperature: 40 ± 2 ℃; Humidity of 95%; Time: 56 days	damage and clear markings,
state		△R≤±（0.5%R+0.05Ω）
		△R≤±（0.5%R+0.05Ω）
	施加電壓：額定功率直流電壓（UR≤U max）	電阻器應無可見損傷且標志清楚
壽命	1.5 小時通電，0.5 小時斷電，總時長 1000 小時	The resistor should have no visible
Life	Applied voltage: rated power DC voltage (UR ≤ U max),	damage and clear markings,
	powered on for 1.5 hours, powered off for 0.5 hours, total	△R≤±（0.5%R+0.05Ω）
	duration 1000 hours
		電阻器無擊穿或飛弧現象，漏電流
耐電壓	施加交流有效值電壓 6KV，時間為 1 分鐘±5 秒	≤10mA
Withstanding	Apply an effective AC voltage of 6KV for 1 minute ± 5	The resistor has no breakdown or
voltage	seconds	arcing phenomenon, and the
		leakage current is ≤ 10mA
	按 GB/T2423.10-2019 要求進行試驗，振動頻率為
	10Hz,振幅 0.35mm，加速度 50m/s?,每個方向 2 次掃頻，	電阻器塑封體應無機械損傷，阻值
振動	3 個方向，每個方向持續時間 23 分鐘	變化在±2%R+0.05Ω之內
Vibrate	Conduct the test according to the requirements of	The plastic casing of the resistor
	GB/T2423.10-2019, with a vibration frequency of 10Hz,	should have no mechanical
	amplitude of 0.35mm, acceleration of 50m/s ?, 2 frequency	damage, and the resistance change
	scans in each direction, 3 directions, and a duration of 23	should be within ± 2% R+0.05 Ω
	minutes in each direction

RTP600

功率型厚膜無感電阻器 Power type Thick film Non inductive Resistor

產品類型	功率	阻值	精度
Product type	Power	Resistance	Accuracy
		3R9=3.9Ω	F：±1%
RTP	600 Watts	10R=10Ω	J： ±5%
		20K=20KΩ	K： ±10%

l 電阻器通過螺絲安裝在散熱器上，螺絲安裝扭矩為 2N.m，應確保產品安裝緊固，無晃動。另外應為螺絲配套防松組件，如：平墊、彈墊、防松螺母等。

l The resistor is installed on the heat sink with screws, and the installation torque of the screws is 2N. m. It should be ensured that the product is installed firmly without shaking. In addition, screws should be equipped with anti loosening components such as flat washers, spring washers, anti loosening nuts, etc.

l 電阻器引出端電氣安裝使用的是 M5 螺絲，螺絲安裝扭矩為 1.3N.m，應確保電氣連接緊固，無晃動。另外應為螺絲配套防松組件，如：平墊、彈墊等，防止振動造成電氣連接松脫。

l M5 screws are used for the electrical installation of the resistor lead out end, with a torque of 1.3N. m. It should be ensured that the electrical connection is tight and there is no shaking. In addition, screws should be equipped with anti loosening components, such as flat washers, spring washers, etc., to prevent electrical connections from loosening due to vibration.

l 電阻器與安裝面之間需要均勻的涂覆一層導熱硅脂，推薦使用導熱系數 1W/mK 的導熱硅脂產品。

l A uniform layer of thermal grease should be applied between the resistor and the installation surface. It is recommended to use thermal grease products with a thermal conductivity of 1W/mK.

l 產品在貯存期間，應貯存在環境溫度為-10℃～+45℃，相對濕度不大于 85% ，通風、干燥、周圍無酸堿或其他有害物質的倉庫內。

l During storage, the product should be stored in a warehouse with an ambient temperature of -10 ℃ to+45 ℃, a relative humidity of no more than 85%, ventilation, dryness, and no acidic, alkaline, or other harmful substances around it

在線詢盤/留言請仔細填寫準確及時的聯系到你!

您的姓名： * 請輸入您的姓名！
聯系手機： * 請輸入您的手機號！
固話電話： * 請輸入您的電話！
聯系郵箱：
所在單位：
需求數量： * 請輸入需求數量！
咨詢內容：我想了解：《RTP600W厚膜無感電阻10Ω100Ω200Ω300Ω500Ω1MΩ》的詳細信息.請商家盡快與我聯系。
您要求廠家給您提供：
規格型號付款條件產品目錄最低訂貨量運送資料提供樣本庫存情況包裝材料

亚洲综合在线播放_久久视频免费在线_久久久黄色av_亚洲免费视频一区

聯系方式

詳細介紹

在線詢盤/留言 請仔細填寫準確及時的聯系到你!

在線詢盤/留言請仔細填寫準確及時的聯系到你!